-40%

W2ENY HiFi replacement mic element for Astatic D-104 amp models T-UG8 T-UG9 Kit

$ 12.14

Availability: 1668 in stock
  • MPN: Does Not Apply
  • Type: MIC ELEMENT
  • All returns accepted: ReturnsNotAccepted
  • Condition: New
  • Brand: W2ENY
  • Compatible Brand: ASTATIC

    Description

    W2ENY HiFi MIC ELEMENT
    My custom design modernizes your old Astatic D-104 with T-UG8 or T-UG9 stand
    (ONLY those stands, please see my other listing for others)
    I've been experimenting with MANY headsets over the last years, I had previously used a Heil headset til now.  This element far exceeds mic specs for optimum use with todays radio technology.
    I designed this application for a direct solder in replacement that brings Hi-Fi audio and new life to my old amplified D-104 (must have amplifier and 9v battery in the T-UG8 stand).  Upgrade your old classic and get good audio reports!!!
    It's a 10 minute job to replace and it works great!!  Features great sound with full range audio, I've been getting nothing but excellent 'ON AIR' audio reports ("Sounds just like you, Bob!").
    50 Hz - 16 kHz wide range FLAT Response - Natural Sound
    Finally, a way to upgrade from that shrill, top end sound offered by similar crystal replacements!
    This auction is only for the "W2ENY HIFI D-104 T-UG8 T-UG9 Replacement" kit with short tinned leads, resistor jumper and new black felt shown in the pic - all else in the pic is shown for illustration only.
    Electret Mic element, resistor/jumper, black felt and instructions are included.
    This replacement is ONLY for D-104s having the TUG8 or TUG9 stand with amplifier and battery,
    if your mic has a board marked PC-100 please see my other listing for the Silver Eagle
    .
    Thanks for looking!
    Basics on how it's done, install pictures come with your purchase:
    Disassemble the microphone head – four screws.
    Insert the mic/felt assembly supplied behind the front screen.
    Solder leads from the neck to the mic as in the instructions.
    Insert some foam to hold the element in place
    Remove bottom cover plate.
    Add resistor jumper assembly as shown in the instructions.
    Reassemble
    NOTE to ebay:  W2ENY is my brand, this is not a duplicate listing as it is for a specific configuration for a specific radio.
    Add a map to your own listings. FREE Trial!